6
Nagra –
HD DAC
After connection of the two LEMO plugs, connect the ACPS II to the mains power
outlet using the IEC cable supplied with each ACPS II module. The red LED should
light indicating correct operation.
If the LED is off, check the connection of the IEC mains cable
and the mains supply to the mains plug. If the problem persists,
please contact your Nagra dealer for assistance.
Before disconnecting the LEMO plugs, ensure that the mains
power has been disconnected and that the main selector on the
front panel of the HD DAC is set to the OFF position.
Grip the fluted section of the plug, between thumb and index
finger as shown in the picture and pull the crown of the
connector backwards.
Connecting to a Nagra MPS
The HD DAC will reveal its full potential with the full chassis power supply
Nagra MPS which was specifically designed to provide several independent power
sources for different NAGRA Hi Fi elements.
The MPS is connected to the HD DAC using LEMO to LEMO cables supplied with
the MPS unit. The LEMO with the black Ring should be plugged into the MPS and
the other end into the HD DAC
If available, we recommend using output 1 for the digital DC input and output 2
for the DC analog input.
Always use the first available output of the MPS for the digital section and the
consecutive one for the analog input.
