13
REMOTE CONTROL
Buttons 1 to 6
This remote control can be used as a common control for
different Nagra products. The buttons 1 to 6 permit to select up
to 6 Nagra products equipped with the remote control receiver.
Dedicating a selected product number to the MPA is made by a
jumper selection inside the machine.
Buttons A to D
Permit to select on the MPA the different line inputs. Buttons E
& F are not used for the MPA.
The main power switch at the backside of the MPA must be in
the ON position.
It is not possible to select an other line input if the MPA is
muted.
ON & OFF
When the ON button is pressed for the first time, the MPA is
powered, the led (red or green) turns green and the backlight
of the modulometer switches on.
When the OFF button is pressed, the MPA goes back to
standby mode and the backlight of the modulometer switches
off. If the MPA was not muted before switching off, the led
stays green, if the MPA was muted before switching off, the led
stays red.
In the OFF status, only the remote receiver stays powered.
Mute
Pressing once on the mute button, the MPA output is muted.
Pressing once the ON button, the outputs are enabled. When
the MPA is muted, the led turns red. If not muted, it turns
green.
Up & Down arrow keys
Adjusts the Volume potentiometer. When continuously
pressing those buttons, the volume will increase or decrease
over a 1/3 of the full range. To continue the adjustment,
release and press again the same button.
Left & Right arrow keys
Adjust the Balance potentiometer.
Center button
Not used with the MPA.
