28
Nagra –
TUBE DAC
IR remote control unit
The remote control unit, with batteries installed, shall not be
exposed to excessive heat such as sunshine, fire or the like.
The TUBE DAC currently comes with the RCU-III IR remote control unit with
Philips RC-5 format encoding. You may also use Nagra RCU or RCU-II IR remote
control unit. Make the necessary setting into REMOTE menu.
Mute
Volume control
Input selection
(-1 in menu list)
Input selection
(+1 in menu
list)
Direct input
selection
Power OFF - ON
Direct input selection (factory setting, but you can inactivate or reorder
inputs in INPUT ASSIGNMENT menu)
A
AES
D
N-LINK 1
B
S/PDIF 1
E
N-LINK 2
C
S/PDIF 2
F
OPTICAL
There is no direct selection key to USB input. Use “+” key to select it.
Input selection with “-” and “+” keys
Press on “-” key to select one input before current input selection in menu list.
Press on “+” key to select one input after current input selection in menu list.
Power OFF - ON key
Toggle key to switch OFF and ON the TUBE DAC. When switching ON, the TUBE
DAC automatically select the last input active before last power OFF.
Note:
This key is only operative when front selector is turned to R position!
Battery installation/exchange
Open the battery drawer by removing the
screw located on the back side of remote
control unit with a small Phillips drive
screwdriver.
Replace empty batteries with either 2x new AAA-Dry cell battery or 2x AAA-
NiMH/NiCd rechargeable battery externally loaded.
By ensuring battery is disposed of correctly, you will help prevent
potential negative consequences for the environment and human
health. The recycling of materials will help to conserve natural
resources. For more detailed information about recycling of
battery, please contact your local authority, your household waste
disposal service or the shop where you purchased the battery.