22
Note
: In counting mode, the weight of the pieces must be even and the weight of
an individual piece should not be less than the readability of the balance.
5.
To return to weighing mode, press “COU” key.
Weighing unit selection
Balance can perform weighing in different measuring units.
In weighing mode press repeatedly “UNIT” key to consecutively display all available
weighing units and select the desired one.
The weighing unit by default is g.
Overload
The weight of the sample cannot exceed the rated maximum capacity of the balance;
when exceeded, the upper line “---------“ will be displayed. Remove the sample
immediately to avoid damages in the balance.
Energy saving mode
Keep pressed COU key for 3 seconds to enter energy saving mode; press COU key
and consecutively will be displayed:
-
CO-Off: display backlit is off
-
CO-1: backlit of display will be off after 1 second of no use.
-
CO-5: backlit of display will be off after 5 seconds of no use.
To exit energy saving mode, press CAL key successively until returning to weighing
mode.
5. MAINTENANCE AND CLEANING
To get the best results and a higher duration of the balance it is essential
to follow the processes of use.
Note:
All the processes of use mentioned below will not have any value unless
you keep a continued and careful maintenance.
Please follow the processes of use of this manual.
This manual should be available for all users of this equipment.
Prevent the balance from sudden movements and knocks, as well as from direct
sunlight or air flows. The balance is a precision instrument, you must handle it
carefully.
Summary of Contents for 5162 Series
Page 38: ...37...
