2 0
Specifications
cds
Frequency Response
10Hz-18kHz ±0.1dB - 0.5bd)
Output Level
2.0V rms at 1kHz
Output Impedance
50 ohms nominal
Phase Response
Linear, absolute phase correct
De-emphasis
±0.1dB referred to main response
Distortion & Noise
<0.1% 10Hz-18kHz at full level
Laser Type
Semiconductor AlGaAs
Wavelength
780nm
Mains Supply
100V, 115V, 230V 50 or 60Hz
Case Size (H x W x D)
76 x 430 x 300 mm
cdx
Frequency Response
10Hz-20kHz ±0.1dB - 0.5bd)
Output Level
2.1V rms at 1kHz
Output Impedance
10 ohms maximum
Phase Response
Linear, absolute phase correct
De-emphasis
±0.1dB referred to main response
Distortion & Noise
<0.1% 10Hz-18kHz at full level
Laser Type
Semiconductor AlGaAs
Wavelength
780nm
Mains Supply
100V, 115V, 230V 50 or 60Hz
Case Size (H x W x D)
76 x 430 x 300 mm
cd5
Frequency Response
10Hz-20kHz ±0.1dB - 0.5bd)
Output Level
2.0V rms at 1kHz
Output Impedance
10 ohms maximum
Phase Response
Linear, absolute phase correct
De-emphasis
±0.25dB referred to main response
Distortion & Noise
<0.1% 10Hz-18kHz at full level
Laser Type
Semiconductor AlGaAs
Wavelength
780nm
Mains Supply
100V, 115V, 230V, 50 or 60Hz
Case Size (H x W x D)
58.4 x 432 x 301 mm
CD Player Maintenance
It is very important for reliable operation of Naim CD players to ensure that the surfaces of the
transport platter and the inside of the disc clamp are free of dust, fibres or other debris which can
prevent the disc from sitting properly, causing it to slip. Although slight, this slippage may make it
difficult or even impossible for the machine to find tracks.
Do not, under any circumstances, use any solvents or fluids for the cleaning process.
cds, cdx and cd5 player
Take a piece of Blu-tak and lightly apply it to the top surface of the magnetic metal hub, picking up
any material attached to it. Brush the plastic outer edge lightly with your finger or a soft brush to
ensure that it is dust and particle free.
Similarly, clean the clamp with Blu-tak, to remove debris from the three locating pins on its underside,
but take care not to damage the rubber pressure pads. Brush them lightly with your finger or a soft
cloth.
