2
UnitiQute Installation and Connection
2.2 Mains Power Connection
Connect UnitiQute to a mains power socket using either
the mains cable supplied or a Naim Power-Line.
2.3 FM/DAB Aerial Connection
In order to enable high quality FM and DAB radio,
UnitiQute requires a, strong, interference-free radio signal.
Its rear panel FM/DAB Aerial socket must be connected,
via 75 Ohm low-loss coaxial cable, to a suitable aerial. The
aerial should be mounted clear of large obstructions and
as high as possible; ideally on a roof.
Note:
Your local retailer should be able to offer advice on
a suitable aerial and aerial installer.
2.4 Audio Signal Connections
2.4.1 Audio Signal Inputs
UnitiQute provides one USB input socket, two stereo
analogue inputs and five S/PDIF digital inputs including
one combined analogue/digital input socket. Connection
to the inputs is made via a variety of socket types. The
following table lists the inputs and their socket type:
Input
Type
Socket
rear panel
Analogue
RCA phonos
front panel
Analogue
3.5mm jack
Digital
3.5mm mini-TosLink jack
dig. 1
Digital
Coaxial (RCA phono)
dig. 2
Digital
Optical (TosLink)
dig. 3
Digital
Coaxial (RCA phono)
dig. 4
Digital
Optical (TosLink)
USB
Digital
USB Type A
Note:
The front panel analogue/digital jack socket can
accept both conventional analogue 3.5mm plugs and
mini-TosLink optical digital plugs. It will automatically
identify the type of plug inserted and handle the signal
appropriately.
Always use high quality interconnect cables to connect
sources to UnitiQute inputs.
2 UnitiQute Installation and Connection
UnitiQute should be installed on an equipment stand intended for the purpose. Do not
stand it directly on top of another item of equipment and ensure it is well ventilated. Care
should be taken to ensure that it is level. It should be installed in its final location before
connecting cables or switching on. UnitiQute has no standby mode and is intended to be
left switched on.
Connecting UnitiQute to mains power and to a variety of audio peripherals and sources
is described in the following paragraphs. Diagram 2.1 illustrates the UnitiQute rear panel
connection sockets.
2.1 UnitiQute Rear Panel
mains input
and fuse
power
switch
signal
ground
switch
preamp
output
network
socket
RS232
socket
left
speaker
right
speaker
digital
output
analogue
input
digital inputs
1 & 3 (coaxial)
digital
inputs 2 & 4
(optical)
DAB/FM
aerial
socket
wireless network (Wi-
Fi) antenna socket
