11
13
（1）Selecting control mode
・Using the control switch (
⑮ in
) you can select between Manual (Front Panel Control) or Auto
External Signal Source can be used to control Motor Start/Stop , Rotational Direction ,
500min
-1
centering rotation .
・Manual Mode-Front Panel Operation.
・Auto Mode-Control by External Signal Source.
（2）Rotation Direction, 500min
-1
centering rotation, Motor Start/Stop.
①Manual Control Mode
・Set rotation direction Push the rotational direction switch ⑭
・Select 500min
-1
centering rotation
Push the 500min
-1
switch ⑯
(Never use 500min
-1
rotation for cutting, this mode is only for
centering on a machining center)
・Motor Start/Stop Push Start switch ⑬, the 'Start' LED will light and the spindle will
rotate. Push the switch again to stop the spindle the LED will turn off
and the spindle will stop rotating.
⑮Control Switch
⑯500min
-1
Switch
⑭Rotational direction Switch
⑬Start Switch
②Auto Control Mode
Use the Input/Output Connector A ⑨ to input control signals to the unit.
・Set motor rotating direction Input the motor rotating direction signal to Pin No. 2:DIR̲IN
Right hand rotation is OFF 'Open'("F.W.D" LED will light)
Left hand rotation is ON 'Closed'("R.E.V" LED will light)
・Set 500min
-1
rotation Input the centering rotation signal to Pin No.16:500min
-1
500min
-1
LED will light
Never use 500min
-1
centering rotation for cutting
