73
English
The side of CONTROLLER
DC+24V
or DC0V
DC+24V
or DC0V
(COM_1)
1
The side of CONTROLLER
DC+24V or DC0V
Load
DC0V or DC+24V
6, 7, 8, 20, 21
（
COM_2
）
18
The side of CONTROLLER
DC0V or +DC+24V
Load
DC+24V or DC0V
(PULSE)
(COM_2)
19
18
②
Output Signal
Ⅰ
There are
5
separete output signals : " Rotating (RUN) ", " Rotating Direction (DIR_OUT) ", " Error (ERR) ",
" WARNING (WARNING) " and " Speed Achievement (COIN) ". These signals are MOSS Relay Contact
Connections. The output current can be connected to either sinking or sourcing.
Voltage and Current Speci
¿
cations
・
Applied Voltage (V)
≦
DC+
30
V
・
Working Current (lp)
≦
100
mA
Use an external power source for output circuits. It is recommended to use the same DC+
24
V power
source used for input signals. Please refer to Fig.
32
for connections.
Fig.
31
③
Output Signal
Ⅱ
Refer to Fig.
33
regarding the Output Signal of the " Rotating Pulse (PULSE) ". The output signal can be
connected for either sinking or sourcing.
Voltage and Current Speci
¿
cations
・
Applied Voltage (V)
≦
DC+
30
V
・
Working Current (lp)
≦
50
mA
Fig.
32
Fig.
33
(
3
) Input / Output Signal
①
Input Signal
There are
8
different input signals : " Rotate Command (START) ", " Rotating Direction Setting (DIR_IN) ",
" Rotates Motorat at " Centering " speed (
500
min
-
1
(rpm)) ", " Error Release (RESET) ", " UP / DOWN
Signal for Setting Motor Speed (UD_IN) ", " Count Pulse Signal for Setting Motor Speed (CNT_IN) ",
" Motor Select
0
(SEL
0
) ", and " Motor Select
1
(SEL
1
) ". These signals are DC+
24
V signals from an
external signal source. Please use a separate power source that is capable of supplying DC+
24
V
±
10
%,
100
mA. Refer to Fig. 31 for connections.
