1. Choose the correct components for Angle Grinder to be used, according to the following table.
Brand
HITACHI
DEWALT
FLEX
MAKITA
METABO
Model
G13SR3/G13SB3
etc.
D28134 etc.
L3410FR etc.
AG8-125Q etc.
AG12-125X etc.
9558NB/9565CV/
GA4530 etc.
GWS8-125 etc.
GWS14-125CI etc.
WE14-125 Plus etc.
Connector
Collar
Flange
(Standard Flange)
(Standard Flange)
Spacer *
* When using a diamond cup wheels with the height 21mm.
MILWAUKEE
BOSCH
PREPARATION
WARNING
・
Be sure to turn off the angle grinder and remove the plug from the electrical outlet in advance.
・
If the connector is loose and cannot be securely attached on the angle grinder, do NOT use HURRICANE in this state.
otherwise it could lead to injury.
GWS8-115/GWS8-125/GWS10-125/
GWS11-125CI/GWS14-125CI
Remove O-Ring
if it is equipped.
O-Ring
INSTALLATION
-2-
Grinder
Guard
Take the Guard off from the Grinder.
T4.5
[d]
(Factory Preset)
[e]
[g]
[h]
[ f ]
[ i ]
[m]
[m]
T4.5
T7.3
(1) Loosen the screws by [k] Wrench and
remove the preset connector.
(2) Set the correct Connector and tighten the
screws. (Don't forget to fit the washers)
Hold 3points of the Connector and tighten
the fitting screws. (2pls.)
When using [f] B-connector,
take the Clamp Piece apart
before setting.
[ f ]
Clamp Piece
[ k ]
[ k ]
WARNING
Make sure HURRICANE is securely
attached, otherwise it may come loose,
causing injury.
Pre-set Connector
( [d] M-Connector )
Fitting screw
FLEX /
Milwaukee
(AG8/AG9 series)
2. Change the Connector. (if needed)
3. Fit on an Angle Grinder.
T7.3
iD16
[p]
[n]
[n]
[o]
Metabo
Tighten 3pcs of TORX screws as
fitted to the angle grinder.
Put [ i ] Collar between a Clamp
Piece and angle grinder.
TORX screw
Clamp Piece
[ i ]
Screw
Washer
Screw
Washer
