6
WWW
.N
AKAYAMA
T
OOLS
.
COM
the fast shift position, and observe whether it reaches the right position or not. Then
the right hand grasps the right handle. (Note: do not grasp the reversing bar)
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller
can run at a fast speed.
④
The right hand increase the throttle properly, the motor can run at a speed of 10
km/h.
3.
Using a receiving shift
①
The left hand pulls grasps the clutch handle tightly and makes the clutch separated.
②
The right hand pulls or pushes the shift bar to the neutral shift and observe whether
it reaches the right position or not. The forefinger of right hand grasps the trigger of
the reversing shift first, then the right hand grasp the reversing handle.
③
Loosen the clutch handle gradually, the clutch will combine, and the power tiller
can run backwards.(Note: do not loosen the reversing handle)
④
When the backward running of the machine is not needed, the left hand holds the
clutch handle gradually, and the right hand loosens the reversing handle.
4.
Shift when the machine is running, reduce the oil valve of the diesel engine (but
subject to the diesel engine’s not quenching), then makes the clutch separated.
When the machine stops running, then shift.
5.
Change directions: pull the handle to left or right to make the machine turn left or
right. (Note: pulling the wrong handle may lead to damage to the gears)
6.
The operation method of recoil/electric starter and safety device
①
Left hand close upon the red emergency stop handle with the handle bar; draw back
the clutch handle with your middle finger and ring finger at the same time. The
above two locks mutual locking cause the engine at the condition which may start.
And now, the operator can recoil –start the engine by hand according to the
indication of instruction manual.
I
f the engine is electric
-
starting model, carry out following two steps.(step2,3 are not
suitable for recoil start engine) connecting well the power supply and control switch as the
electric start hookup(or connect it beforehand).
I
f the power tiller without power supply,
you should prepare a lead
-
acid battery accord with direct current 12V, 18AH.
When you run
hoe
firstly or don't use it
in long time, pls. start it by recoil.
②
Clockwise turn the starting-key to the start position after inspects unmistakably, and
then release the key after the engine started, it will return to the primary position
automatically.
③
Adjust the throttling cock to the right position after the engine started.
