Nakayama ET6000, Quick Start Manual

EN

WWW.NAKAYAMATOOLS.COM

5

Adjusting the angle of auxiliary handle (see Figure)

Undo the adjustment lock knob for the auxiliary handle until it can be moved forwards or backwards 

without any great resistance. Set the required position and tighten the lock knob again.

Adjusting the angle of motor head motor (see Figure)

Press the button for the angle of adjustment to choose a fit position. Five different locking angles 

are possible.

Height adjustment (see Figure)

Undo the union nut until the grass trimmer handle can be moved in and out freely. Now 

set the required working height and secure the handle in this position by tightening the 

union nut again.

Connect the power plug and extension cable.

Operation 

Switching the trimmer on: 

Press lock off (11), then press switch trigger (10) on the handle. 

Switching the trimmer off:

Release the switch trigger (10) on the handle. 

Using the grass trimmer as an edge trimmer:

To cut the edges of lawns and flower beds, the grass trimmer can be converted as follows:

Pull the lock for the rotatable motor head in the direction of the arrow as shown on lock

-

ing cover.

Turn the motor head through 90⁰ in the required direction until it latches in place.

Now you have converted the grass trimmer to an edge trimmer for cutting the lawn verti

-

cally.

Warning!

 Cutting elements continue to rotate for a moment after the motor is switched off.

Warning! 

Always switch off machine before placing it down.

Cutting (trimming) 

Hold the trimmer in front of the body at an inclined angle and guide in a semicircular motion around the standing position.

Good cutting performance up to a grass height of 15cm. Cut down higher grass in stages.

CAUTION:

 Don’t bring the top of the wire spool housing into contact with the ground when the machine is running.

If poor cutting performance is occurred:

1) If the Nylon line is too short when you start the equipment for the first time, Please turn off and on several times, the line 

will be cut to the perfect length automatically.

2) If the Nylon line is too long when you use the equipment for the first time, The surplus end of it will be cut by the blade on 

the protective cover to the correct length.

If the tool is vibrating.

Clean the tool; remove grass in between the reel fixture and the cover.