Nakayama PRO NS5210, Manual

Stopping the sprayer after completing spraying

a) Remove the chemical tank drain cap, and drain off all of the chemicals.

B) Fill the chemical tank with clear water, operate the engine, and clean the pump and hose interior by spraying the clean 

water. Drain off remaining water through the drain.

Start the engine at just less than high speed for 15- 20 seconds to spray out the water in the spray hose and nozzle. When water stops coming from the 

nozzle, turn off the engine at once. 

Stopping the machine (Pictures L - R)  

Temporary halt during operation

a) Close the nozzle, and return the throttle lever to low speed.

b) Press the engine stop button.

c) After the engine stops, set the sprayer down and close the fuel cock. 

L(1): Close

M(2): Slow running

N(3): Push

Maintenance (Picture Q)

Cleaning the air filter 

Remove the air filter cap to clean the element. Soak the element in gasoline then soak in oil and squeeze dry firmly. Allow it to dry well before replacing it.

Spark plug 

Pull the starter rope 2-3 times, dry the spark plug and remove the carbon residues.

Adjust the spark plug gap (proper state: 0.8mm).

Storage

After using the sprayer for the season, store it until the next season of use as follows:

a) Drain off all fuel from the fuel tank and the carburettor.

b) Remove the spark plug and coat the interior of the cylinder with a small amount of oil. Pull the recoil starter lightly 2-3 times to spread the oil over the 

cylinder completely.

c) Pull the recoil starter out slightly and stop it in place where you fuel the pull starter (compression starts).

d) Clean the entire sprayer completely, cover it so it does not accumulate dirt and dust, and store it in a dry, co

ol

place

.

* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes 

significantly affect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may 

also concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.

* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection or replacement work, including maintenance and special 

adjustments, must only be carried out by technicians of the authorized service department of the manufacturer. 

* Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious 

injury 

or death. The manufacturer and the importer shall not be liable for injuries and damages resulting from the use of non-conforming equipment.

O(1): Connecting nut

P(2): Drain cap

EN

WWW.NIKOLAOUTOOLS.GR

5