6. CONTROL PANEL OPERATION
www.naked-pools.com
16
BEFORE ENTERING BACKWASH MODE YOU MUST BE IN THE DDS SCREEN.
[BACKWASH] button assists you in the operation of your pump and lter during the backwash process.
[BACKWASH] can also be entered by pressing the [OK] button in the MAIN MENU and scrolling to BACKWASH MODE.
ALWAYS FOLLOW MANUFACTURERS INSTRUCTIONS.
IF UNSURE PERFORM MANUALLY BY PRESSING POWER/MODE ON&OFF TO
DO THE FILTER CLEAN.
During BACKWASH the [POWER/MODE] button displays the ON LED when the pump is
running and the OFF LED displays when the pump is stopped.
CARTRIDGE FILTER: If you have a cartridge style lter you can now perform all your required cleaning functions.
P
ress [<] or [BACKWASH] to exit.
S
AND, GLASS or D.E. FILTER: If you have these lters, rotate the lter multi-port valve to the backwash position, ensure
the handle locks are in place and once ready press [OK] to enter the [BACKWASH MODE] cycle.
Pressing [OK] starts the pump for 1 minute and TIME LEFT will be displayed
automatically counting down in 1 sec increments.
Once dirty water in the waste pipe or sight glass is clear press [OK] to nish.
RINSE MODE will then be displayed.
Pressing [OK] stops the pump and RINSE MODE is displayed.
Rotate the lter multi-port valve to the backwash position, ensure the handle locks in
place and once ready press [OK] to enter the RINSE MODE cycle.
Pressing [<] or [BACKWASH] allows you to exit and this takes you to BACKWASH
COMPLETE.
Pressing the [OK] button starts the pump for 1 minute.
TIME LEFT automatically starts counting down in 1 sec increments.
Once dirty water in the waste pipe or sight glass is clear then press [OK] to nish RINSE
MODE and enter BACKWASH COMPLETE MODE.
Pressing [OK] stops the pump and BACKWASH COMPLETED
is displayed.
Rotate the lter multi-port valve to the lter position, ensure the handle locks in
place and once ready press [OK] to enter the nal BACKWASH COMPLETED cycle.
Pressing [<] or [BACKWASH] allows you to exit.
BACKWASH COMPLETED is displayed and the pump
remains
stopped.
This gives you time to ensure all lids are resealed and that all the required ow valves
are returned to their correct positions. Do a nal check that everything is in the correct
positions and sealed.
Press [BACKWASH] to exit the BACKWASH COMPLETED mode and you will return to the
DDS screen.
6.6 BACKWASH
IMPORTANT INFORMATION BEFORE PERFORMING A BACKWASH.
NEVER OPERATE THE FILTER LEVER WHILE THE PUMP IS RUNNING YOU MAY DAMAGE THE
SEAL AND LEAKS MAY OCCUR.
THE PUMP WILL START AND STOP AS YOU REQUIRE.
ENSURE ALL THE VALVES, VALVE HANDLE, LIDS, BASKETS, ETC. ARE IN THE CORRECT
POSITIONS AS PER THE REQUIREMENTS OF THE MANUFACTURERS OF THAT EQUIPMENT.
