3.Line up the axle lock washers (These are the metal washer with a bent
tab on one side) with the hole at each fork.
Notice:
These two special
fork lock washers keep the wheel from falling off if the axle nuts ever
loosen up! Tighten the axle nuts by hand.
4.Tighten both axle nuts with the supplied double open-end wrench.
Notice:
Before doing the final tightening of the axle nuts，make sure the
wheel is square and true with the forks.
Summary of Contents for Discovery
Page 1: ...Discovery...
Page 6: ...2 Remove and discard plastic spacer 3 Install the handlebar onto the steer stem...
Page 23: ......
