AL3A-RM User Guide Version B
Document Number: 451-93156-002B
57 of 172
B.41
+CMOD
–
C
ALL
M
ODE
Set Command:
+CMOD=[<mode>]
Set command selects the call mode of further dialing commands (D) or for next
answering command (A). Mode can be either single or alternating (the terms
"alternating mode" and "alternating call" refer to all GSM bearer and tele-services
that incorporate more than one basic service (voice, data, fax) within one call). For
the satellite modem, only a single call is supported.
<mode>:
single mode (default)
Read Command:
+CMOD?
Query the current call mode settings. The response is in the form:
+CMOD: <mode>
Test Command:
+CMOD=?
List the supported call modes. The response is in the form:
+CMOD: (supported <mode>s)
B.42
+CNMI
–
N
EW
SMS
M
ESSAGE
I
NDICATIONS TO
DTE
Set Command:
+CNMI=[<mode>[,<mt>[,<bm>[,<ds>[, <bfr>]]]]]
Set command selects the procedure, how receiving of new messages from the
network is indicated to the DTE when DTE is active, e.g. DTR signal is ON.
Valid values for <mode> are:
Buffer unsolicited result codes in the A3LA-RM. If result code buffer is full, older
indications are discarded and replaced with the new received indications. (default)
Discard indication and reject new received message unsolicited result codes when
A3LA-RM-DTE link is reserved (e.g. in in-call data mode). Otherwise forward them
directly to the DTE.
Buffer unsolicited result codes in the A3LA-RM when A3LA-RM-DTE link is reserved
(e.g. in in-call data mode) and flush them to the DTE after reservation. Otherwise
forward them directly to the DTE.
