521-OM0108.88
Copyright
2009 Nalco Company
6-16
Technical Help
(630) 305-CHEM
3D TRASAR
5500 - Installation & Operation Manual
!
Figure PF8
Remove these four screws
Exit tube covered by shield
6.9.3 Pellet Shield Replacement (con’t)
STEP 2
-
Refer to the MSDS sheet for Safe Handling Procedures and Safety Equipment
required before proceeding!
Wearing a minimum of rubber gloves and dust mask, clean out any product from the Pellet
Feeder hopper. Do not use water! Contact with the product will cause a blue “stain”. Avoid
contact. The stain is not permanent and will wash away.
STEP 3 -
Turn off power
STEP 4
-
Loosen the four screws and washers holding the tabs of the pellet
shield. Note the orientation to the ‘Exit Tube’ (shown in drawings).
STEP 5
-
Remove the pellet shield, rotor retainer, and screws/washers as a unit.