3D TRASAR
5500 - Installation & Operation Manual
521-OM0108.88
Copyright
2009 Nalco Company
Technical Help
(630) 305-CHEM
E-7
Blowdown Rate
Information
à
Water & Energy
à
Blowdown*
*Controller must be configured for Blowdown Control to be visible
Makeup Rate
Information
à
Water & Energy
à
Makeup
Analog Input 1
Information
à
External Inputs
à
4-20 Input 1
Analog Input 2
Information
à
External Inputs
à
4-20 Input 2
System Volume Average
Information
à
Water & Energy
à
Sys. Vol.
Heat Rejected
Information
à
Water & Energy
à
Heat Rej.
Recirculation Rate
Information
à
Water & Energy
à
Recirc Rate
Note
: Some variables may not appear on the display if the controller is not configured to use them.
These variable(s) should be ignored when processing the Modbus block register response.
LAN - Direct connect via crossover LAN cable
The Controller provides the following Ethernet/email settings. The factory defaults can be modified
as needed (on site). Power must be cycled before any changes “take effect” in the Controller
.
Settings accessed from the 3D TRASAR Controller display
• DHCP: Disable (Nalco recommends leaving this setting disabled)
• IP Address: 169.254.1.2 (factory default)
• Subnet Mask: 255.255.0.0 (factory default)
• Gateway Address: 169.254.1.4 (factory default)
Settings accessed using the 3D TRASAR Configurator
• Controller Name: CustomerName@3dtrasar.com (In some cases this address will need to
be modified. For example, trasar5000@att.net. Contact Nalco Technical Support for help)
• DNS Server: (Supplied by customer IS Department)
• Mail Server Name/IP: (Supplied by customer IS Department)
• Alarm Email Address: alarms@3dtrasar.com (Alarm Server address located at Nalco
Company)
• Data Email Address: data@3dtrasar.com (Data Server address located at Nalco Company.
This email address is not changeable without contacting Nalco Technical Support)
