6-7
COIN OPTIONS (Setting of play fees)
Coin options such as the credit needed to play one game play shall be set here.
1
Perform the procedure 4 of “6-l-2 Selecting the Adjusting Items”
Select
“COIN OPTIONS” in 3.
The following screen is displayed.
COIN OPTIONS
<DEFAULTS IN GREEN>
VALUE:
VALUE:
EXIT
:
2
Hit the
S-direction joystick up or down to select an item to change the setting out of(a) (g)
on the above figure. The selected item is highlighted in red.
l
Before changing the settings of (a)
be sure to set
(g)
PLAY”.
The settings of (a)
cannot be changed if(g) is set ON.
3
Hit the
S-direction joystick right or left to change the setting.
S-direction joystick
Note: The above figure shows the pair control panel. In case of the single control panel
(that is, two cabinets corresponding to the
VIDEO standard
are
linked for networked head-to-head play), the control
of the cabinet on which
the
board is installed shall
called as PI.
The details of the setting of each item are as follows. (The default setting out of factory is
shown by the thick frame here.)
(a)
START COST (The number of coin(s) needed to play an initial game play)
I
2 3 4 5 6 7 8 9
COIN(S) TO START
(b)
CONTINUE COST (the number of coin(s) needed to play a continued play)
I
2 3 4 5 6
8 9
COIN(S) TO
CONTINUE
Note: This value should be the same value as (a)START COST or smaller.
Summary of Contents for Tekken Tag Tournament
Page 1: ......
Page 56: ...11 APPENDIX A Control Panel Layout Template Electrical Diagram 54...
Page 58: ...00 ti OG Z 00 0 66 0 6 1...
Page 59: ...3...
