12
③
Set the address of the DMX512 console to be consistent with the light fixture.
④
Refer to the attached DMX channel list and control the light via DMX512. (For specific operation methods, please
refer to the DMX512 console operation manual.)
Note: DMX Channel List
《
Forza 300B DMX Channel List (NANLITE)
》
please download it from www.nanlite.com
3. 2.4G Remote Control
Set the address of the 2.4G remote controller to be consistent with the light fixture, then the light fixture can be
remotely controlled by the WS-RC-C2 remote controller or by APP via the transmitter box.
Note:
①
2.4G remote controller and Transmitter Box are sold separately.
②
The fixture supports the 2.4G wireless protocol V1.0 and V2.0. Set fixture to V2.0 while using WS-RC-C1
or WS-RC-C2 remote controller. Set fixture to V1.0 while using other remote controllers.
(See the opreation on the manual of P33.)
②
DMX Circuit
ln DMX mode, make sure the last light is the only light with a cable connected to DMX output. There is a resistance
about 120(OHM) between the second pin and third pin of this plug (as shown). Make sure this plug can be
installedinto the output of the last fixture, this will help avoid noise and reflection phenomenon caused by the DMX
signal during the transmitting process.
DMX circuit connection
Connect a 120(OHM) resistance
between the 2pin and 3pin of the
XLR plug and then connect it to the
DMX output socket of the last fixture.
1
3
2
120Ω
PIN 2 PIN 3
