15
②
DMX Terminator
ln DMX control mode, the DMX output of the last light fixture should be connected with a DMX terminator
(not included). The terminator is connected with a 120Ω(OHM) resistor across Pin 2 and Pin 3 (As shown below).
This prevents interference caused by DMX signals in the transmitting process.
DMX Terminator Connection
Connect a 120Ω(OHM) resistor
across Pin 2 and Pin 3 in an XLR
plug and insert into the DMX OUT
socket on the last unit.
PIN 2 PIN 3
120Ω
1
2
3
5
4
③
Address Setting of the Light Fixtutre.
④
Refer to the DMX reference guide and control the light via DMX/RDM console.
(For detailed operation please refer to the DMX/RDM console operation manual.)
Note: DMX reference guide "Forza_720B_DMX_REFERENCE_GUIDE_EN" is downloadable from
www.nanlite.com.
