57
AFTER RUNNING
STOPPING THE ENGINE
CAUTION !
Never stop the engine by using the main switch. This
could damage the electrical system.
Before stopping the engine, let it run at idle in neutral for
few minutes, especially if the engine has been operated
at high speed and load. This will allow the coolant to
cool down the engine.
1.
Start the fan in the engine compartment (if fitted) or
open the hold.
2. Turn the key of the starter switch counter-clockwise,
the engine stops and all indicators turn off. The
engine stops, all lamps go out. For panel without
key, press the ON/STOP button and release it. The
engine stops. Turn the key of the main panel counter-
clockwise. All indicators will turn off.
.
S07
STARTING & RUNNING
AFTER STOPPING THE ENGINE
CAUTION !
Even after the engine has stopped, some components
and fluids will remain hot and under pressure for several
minutes. As far as possible, limit works on the engine
immediately after stopping it. Allow it to cool down first.
After the engine has stopped :
1. Turn off the main switch.
2. Close the sea cock and the fuel cock.
3.
Inspect the engine compartment and check for leaks.
CAUTION !
If the boat is being towed, put the lever in neutral, stop
the engine and close the sea cock to prevent the engine
from being filled with raw water.
On a twin-engine boat, if cruising with a single engine,
close the sea cock of the stopped engine.
Do not forget to open the sea cock before restarting the
engine.
Summary of Contents for N16.1000 CR3
