47
S06
STARTING & RUNNING
ELECTRIC SYSTEM
The electrical harness of the generating set must be kept
away from any splash of water and must be correctly
fixed as high as possible in the hold.
The electrical diagrams related to the generator set are in
the Maintenance chapter.
PRELIMINARY CHECKS
DANGER!
All covers must be put back in place beore starting the
genset.
CAUTION!
Open the sea cock before starting the engine. The raw
water pump impeller will be damaged if it runs dry, even
for a few seconds, and may cause the engine to overheat.
Perform the following before starting the engine:
1. Open the sea cock. Prime if required.
2. Start the compartment fan (if applicable) for at least
five minutes. Otherwise, open the bilge.
3. Check the fuel level.
4. Turn the control lever to Neutral.
5. Open the fuel valve. Prime if necessary.
6. Check engine and transmission oil level and adjust if
necessary.
7. Check coolant level, and adjust if necessary.
8. Check mechanical cables and lubricate as needed.
9. Check for fluid leaks.
10. Check alternator belt tension.
11. Apply power to the electrical system.
Summary of Contents for Q1100 Series
