62
S 07
MAINTENANCE
EXHAUST ELBOW INSPECTIONS
Aluminum wet exhaust elbow :
Disassembly
• Unscrew and remove the 4 bolts (1).
• Remove the exhaust elbow (2) with its gasket (3).
• Inspect the exhaust inside and outside for corro-
sion and/or leaks. Replace if necessary.
Installation
• If necessary, install a new exhaust elbow with a
new gasket.
• Tighten the 4 bolts.
IMPORTANT!
On this type of elbow, there is no anode, so there is no
need to check or replace the zinc anodes.
Stainless steel dry exhaust elbow (optional for the
non-soundproof version):
Disassembly
• Unscrew and remove the 4 bolts (1).
• Remove the exhaust elbow (2) with its gasket (3).
• Inspect exhaust inside and outside for corrosion
and/or leaks. Replace if necessary.
Installation
• If necessary, install a new exhaust elbow with a
new gasket.
• Tighten the 4 bolts.
IMPORTANT!
This type of elbow does not have an anode. There is no
need to check or replace the zinc anodes.
Summary of Contents for Q1100 Series
