28
S04
WARRANTY
EPA WARRANTY
EPA and CARB warranties only apply to new engines hav
-
ing the certification label affixed to the engine and sold as
stated above in the geographic areas.
The presence of an EU number signifies that the engine
has been certified with the European Union countries
per Directive 97/68/EC. The EPA and/or CARB emissions
warranties do not apply to the EU countries.
When applied onto engine, Emission Control label must
never be removed from engine block neither covered with
a layer of paint. This label is the evidence showing that
the engine is meeting U.S emissions regulations. It must
be kept available at anytime once the vessel has entered
waters being in the scope of the North American Emission
Control Area (ECA).
Emission Control System(s) Laws
The U.S. EPA and CARB prohibit the removal or rendering
inoperative of any device or element of design installed
on or in engines/equipment in compliance with applicable
emission regulations prior to or after the sale and delivery
of the engines/equipment to the ultimate purchaser.
European Union (EU) Declaration of Emissions
Conformity
The presence of an EU number on the label signifies that
the Marine Diesel Engine has been certified with the Euro
-
pean Union countries per Directives 97/68/EC as amend
-
ed by Directive 2004/26/EC. The EU engine family is listed
on the Emissions Label.
When installed in accordance with the manufacturer’s
instructions, Nanni Industries Marine Diesel Propulsion
Engines without integral exhaust certified under Direc
-
tive 97/68/EC as amended by Directive 2004/26/EC pro
-
duce exhaust emissions of carbon monoxide, hydrocar
-
bons, nitrogen oxides and particle emissions complying
with the requirements of the Recreational Craft Directive
2003/44/EC.
ALTERNATOR IDENTIFICA-
TION
The characteristics of the alternator are mentioned on its
type nameplate affixed to its casing. Never remove it or
cover it with paint.
If the nameplate went to be missing at some stage, it
would become very difficult to quickly determine the cor
-
responding characteristics of the alternator.
Above : I.D plate of an alternator.
NOTE!
The generator sets are designed for long term service.
There are no serviceable parts inside the alternator for
the end user. In the event of a fault, consult your nearest
NANNI representative.
The alternator identification plate provides to the marine
electrician in charge of the installation, all the information
needed to define the entire electrical system on board the
vessel.
NOTE!
Any modification to the alternator will void the warranty
and will be in opposition to safety regulations.
IMPORTANT!
To ensure than your generating set will always deliver ef-
ficient operation when required, start the engine and run it
loaded between 50-70 % for 30 minutes every two weeks.
DO NOT
allow the generator set to run unloaded for an
extended period of time.
Summary of Contents for Q1500 Series
