64
DRAINING THE ENGINE OIL
PRINCIPLE OF OPERATION :
1. Start the engine and let it warm a few minutes to
render oil more fluid to ease suction.
2. Stop the engine and remove the key from the panel.
3. Remove the clamp at the lower side of the flexible
duct between oil sniffer and oil pan (red arrow on
below picture).
4. Connect the duct of the oil draining pump to the rigid
metal tubing going to the oil pan.
5.
Remove the oil filling cap.
6. Pump all the oil remaining in the oil pan.
7. Remove the pump and redo the connections, in
making sure that the clamp is secured properly.
Above picture: how to drain oil from engine.
Draining with external oil pump:
Oil draining may also be performed through an external
pump connected to the oil check dipstick duct.
S08
MAINTENANCE
REPLACING THE OIL FILTER
Replace the oil filter every time the engine oil is drained.
1.
Remove the oil filter with a filter wrench tool. Turn the
filter counter-clockwise (CCW). Remove the gasket.
2. Clean the mating surface in order to prevent impurities
from entering the engine.
3.
Apply a film of oil on the new gasket. Screw the new
filter by hand with the new gasket. When the gasket
contacts the mating surface, turn the filter a half turn.
4. Fill with proper amount of new oil. Check for leaks and
check the oil level.
5. Start the engine and let it operate few minutes at idle.
Check if the oil pressure warning lamp turns off.
6. Stop the engine, wait for the engine to cool down and
check the oil level. Top up if necessary.
Summary of Contents for T6.280
