Wipe
Dip
Dip
To clean the bearings disassemble the engine by following
the assembly instructions backwards until you can remove
the bearing bracket and front plate from the engine.
Dip the end of the bearing bracket in methylated spirits or
denatured alcohol to soak the bearings. Allow to dry
naturally or blow dry with compressed air.
Reassemble the engine.
To clean the piston disassemble
the engine by following the
assembly instructions backwards
until you can remove the piston
and connecting rod from the
engine.
Wipe with a paper towel or
tissue.
Dip the bearing end of the
connecting rod in methylated
spirits or denatured alcohol to
soak the bearing. Allow to dry
naturally or blow dry with
compressed air.
Reassemble the engine.
If the engine runs slowly the piston or bearings might need cleaning.
Nano Flux Twin Assembly instructions page 26 of 27
Copyright Kontax Engineering Ltd 2019
