SETTING
PARKING GUARD
When you have turned off your engine, the nanoQ camera will detect
the battery voltage change and launch Parking Guard mode
(connected Parking Guard hardwire kit). The video recording will be
low frame rate to save storage space. Once any impact over the
threshold value is detected, the camera will change to normal
recording mode to save a 30 second video clip. This file will be
protected from over-write by the loop recording function.
(You need a Parking Guard hardwire kit to support the Parking Guard
function, which is an optional accessory.)
options:
OFF
ON
BOOT SOUND
Here you can active / disable the boot sound and button sound
options:
ON
OFF
INDICATORS
Here you can active / disable the indicators.
options:
ON
OFF
BLUE INDICATOR
Here you can define the indicating function of the green indicators.
options:
GPS STATUS
MIC STATUS
PARKING GUARD STATUS
OFF
POWER OFF DELAY
If there are no button actions when the camera is on standby, the
camera will auto power off to save power (Unless the camera is on
Motion Detection mode or Parking Guard mode). Here you can
define the delay time.
options:
1 MIN
3 MIN
5 MIN
SCREEN OFF DELAY
If there are no button actions when the camera is on standby or
recording, the camera will auto turn off the screen to save power.
(You can press the POWER button to turn on/off screen at any time.)
Here you can define the delay time.
options:
15 SEC
30 SEC
1 MIN
3 MIN
5 MIN
Summary of Contents for Q
Page 16: ...MORE THAN A DASH CAMERA nanoq...