27
Zetasinter System
®
12.
Quick start procedure
HEATING CURVE SETTING
1.
Turn on the temperature controller by turning the LOCK button.
2.
The temperature controller is initializing and then displays the initial screen.
3.
Press the LETF ARROW button to display the heating curve setting.
4.
The screen is now displaying the first segment (
C 01
) and the associated temperature. This
temperature can be modified by pressing the UP or DOWN ARROWS. After pressing the UP or
DOWN ARROWS for a few second, the decimal point will be displaced to the left in order to change
the temperature faster. With the side arrows, you can choose to change the number of units, tens,
hundreds...
5.
Once the first temperature is set, press the CYCLE button to move to the first segment time setting
(
T 01
). You can change the time displayed in minutes by pressing the UP or DOWN ARROWS. With
the side arrow, you can choose to change the number of units, tens, hundreds...
6.
Then you can cycle through the segment by pressing the CYCLE button to build the desired heating
curve. The number displayed by the letter C or T corresponds to the number of the segment.
7.
Note that a plateau can be added by choosing the same temperature as the temperature of the
previous segment. If so, the time setting of that segment corresponds to the time of the plateau.
8.
Finally, when all segments are built, you must add a final step by choosing -121 as the temperature
of the last segment and not assigning any time control to this step.
9.
In order to exit the heating curve setting, you can wait 20s and the temperature controller will
automatically return to the initial screen. You can check your heating curve by entering the heating
curve setting again (back to point 3).
RUN A HEATING CURVE
1.
To run the selected heating curve, you must first press the TURN ON button to close the circuit
breaker. The green button will light up.
2.
Press the DOWN ARROW (run) for more than one second to start the heating curve.
3.
You can hold the heating curve by pressing the DOWN ARROW for a little longer than one second. To
resume the heating curve, press the DOWN ARROW again for more than one second. You can stop
the heating curve by pressing the UP ARROW for more than one second.
