MIDI
-sync
In a MIDI setup, Nanoloop can only be slave. To start master and slave
synchronously, set Nanoloop to slave mode by pressing B and then start the master.
In most cases this is all you need to do. To change the sync-time base (1/1, 1/2, etc.)
press A + LEFT / RIGHT. Default is 1/8.
On master speed changes, Nanoloop (or the master) may skip single MIDI sync
signals. To correct this A + UP / DOWN adds / subtracts sync-steps (1/6 step).
Anyway, in most situations it may be much easier to simply stop the master for a
second. When not receiving sync signals for a certain period (about one second),
Nanoloop flips back to the first step and waits for the master to start.
Latency time is about two milliseconds.