Document # 700075-0000R
April 23, 2020
iii
WIRELESS
ULTRA SYSTEM
OWNER’s Manual
Information to the User
This equipment must be installed and used in strict accordance with the manufacturer's
instructions. However, there is no guarantee that interference to radio communications will not
occur in a particular commercial installation. If this equipment does cause interference, which can
be determined by turning the equipment off and on, the user is encouraged to contact Nanoptix
Inc. immediately.
Nanoptix Inc. is not responsible for any radio or television interference caused by unauthorized
modification of this equipment or the substitution or attachment of connecting cables and
equipment other than those specified by Nanoptix Inc. The correction of interferences caused by
such unauthorized modification, substitution or attachment will be the responsibility of the user.
In order to ensure compliance with the Product Safety, FCC and CE marking requirements, you
must use the power supply, power cord, and interface cables, which were shipped with this
product or which meet the following parameters:
Power Supply
UL Listed power supply with standard 60Hz-50Hz, 100-240VAC input and 12VDC isolated output
for the Game Interfaces, 24VDC output for the Spill Proof printer. Power supplies used must be
equipped with AC line filtering, over-current and short-circuit protection. The use of these
products with a power supply other than a Nanoptix Inc. approved one will require you to test the
power supply with the Nanoptix Inc. product for FCC and CE mark certification.
Communication Interface Cable
An approved Nanoptix interface cable must be used with this product. Use of a cable other than
Nanoptix approved product will require that you test the cable with the Nanoptix Inc. printer and
your system for FCC and CE mark certification.
Power Cord
A UL listed, detachable power cord must be used. A power cord with Type SVT marking must be
used. For applications outside North America, power cords that meet the particular country’s
certification and application requirements should be used.
The use of a power cord other than described here may result in a violation of safety certifications
that is in force in the country of use.
Industry Canada (IC)
Radio Frequency Interference Statement
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le
matériel brouilleur du Canada.
NOTE:
Information contained in this manual applies to the following
firmware versions:
Controller Box - Host:
1.0O
Controller Box - Game:
1.0K
Spill Proof Printer:
5.64A
Zigbee Module:
4060
