page
11
www.naoclean.com
Refill the tank with tap water
and clean once again.
How to clean with disinfectant
1.
2.
3.
4.
5.
6.
7.
8.
9.
Measure a suitable amount of clean, refined salt with 88% salinity (or higher) with
the measuring cup, and put it into the dilution bottle.
Add tap water to 2/3L of the bottle and melt them completely.
Pour it into the tank and add tap water to 25 or 50L line.
Connect the power plug.
Press the main
Power switch. (At the initial operation, spray may not work properly
with idling of the motor because water has not been supplied to the pump yet.
In such a case, pull the spray gun trigger several times until the spray works
normally.)
If there is a problem with the high-pressure spray, wait a few moments until the
air inside is completely removed before attempting to use the device again.
Press the
Disinfectant button.
Hold the spray gun with two hands (because of high-pressure), aim it toward
your target area and shoot it. (You can choose the type of spray nozzle.)
After using the disinfectant, please refill the tank with tap water and clean inside
the device by running it once again.
-
-
-
-
-
-
Make sure to dissolve the prescribed amount of salt completely
before pouring it into the tank. (Too much salt may cause an er-
ror preventing disinfectant from being generated. In such a case,
turn off the
Disinfectant button, drain some of the salt water from
the tank by pulling the spray gun trigger and add some water in
the tank to lower the concentration of the salt water. After that,
turn on the
Disinfectant button, and try again.)
Do not leave salt water in the storage tank for an extended
period of time.
Make sure to use just the right amount of disinfectant as needed.
If it is used on ferrous material, rinse with clean water after using.
It may cause corrosion. (Refer to page 16)
When you are not using disinfectant, turn off the
Disinfectant
button.
If the device is not powered up even after it is properly plugged
up and switched on, turn on the leakage circuit breaker.
(ELCB)
(Refer to page 6)
※Precautions for cleaning with disinfectant
2. About product >
Components / Specification & Features /
How to use
/ Applications
Use the disinfectant.
Salt 200g : Water 50L
Salt 100g : Water 25L
