Napa 6-1012, Instruction Manual

Rev. 5/29/02

Always place a chisel in the hammer
and hold the tool down to the
work before operating. Damage to
the tool or the retainer may result
if this precaution is not followed.

The chisel retainers are not
designed for complete safety
against accidental release of cutters
or hammers. To avoid injury, the
throttle must never be depressed
unless the chisel is held firmly

against the work place. When tool
is not in actual use, the chisel must
be removed. During operation,
safety goggles should always be
used to guard against flying rust
and chips. When using tool, 
regulate the speed so that the 
chisel is not being driven out of 
the cylinder. If piston is allowed to
strike the cylinder wall, internal
damage will result.

To change chisel, pull back on the
retainer and insert chisel. Release
retainer.

To regulate air, turn air regulator
knob out for maximum air pressure
and in for minimum.

OPERATION

PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.

4

S

PECIFICATIONS

Blows Per Minute ........2,200 BPM min.

Bore Diameter ................................3/4"

Piston Stroke................................3-3/4"

Air Inlet Thread ......................1/4" NPT

Hose Size ..................................3/8" I.D.

Avg. Air Consumption..................4 cfm

Rec. Air Pressure ..........90 psig (6.2bar)

Sound Level..............................110 dBA

Length ........................................10.63"

Shipping Weight ....................5.66 Lbs.

Air Inlet

Air Regulator