PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION. SAVE THIS MANUAL FOR FUTURE REFERENCE.
Tools of this class operate on a wide
range of air pressures. It is
recommended that air pressure of
these tools measures 90 PSI at the
tool while running free. Low
pressure (under 90 psig; 6.2 bar)
reduces the speed of all air tools.
Low air pressure not only wastes
time, but also costs money. Higher
pressure (over 90 psig; 6.2 bar)
raises performance beyond the
rated capacity of the tool, which
will shorten tool life because of
faster wear and could cause injury.
Always use clean, dry air. Dust,
corrosive fumes and/or water in the
air line will cause damage to the
tool. Drain the air tank daily. Clean
the air inlet filter screen on at least
a weekly schedule. The
recommended hookup procedure
can be viewed in the above figure.
The air inlet used for connecting
air supply, has standard 1/4" NPT
American Thread. Line pressure
should be increased to compensate
for unusually long air hoses (over
25 feet). Minimum hose diameter
should be 3/8" I.D. and fittings
should have the same inside
dimensions and be tightly secured.
Nipple
AIR SUPPLY
LUBRICATION
Lubricate the air motor daily with
NAPA air tool oil. If no air line
oiler is used, run 1/2 ounce of oil
through the tool. The oil can be
squirted into the tool air inlet or
into the hose at the nearest
connection to the air supply, then
run the tool. Overfilling will cause a
reduction in the power of the tool.
