6-767
5
Rev. 07/17/19
The air regulator knob can be used
as an air throttle, if there are no other
means of regulating air. Turn the air
regulator knob all the way to highest
position for maximum power.
The air regulator can be used to
adjust torque to the ap
prox
i
mate
tightness of a known fastener. When
tight en ing nuts not requiring critical
torque values, run nut up flush and
then tighten an additional onequarter
to onehalf turn (slight ad
di
tion
al
turning is necessary if gaskets are
being clamped). For additional power
needed on dis as sem bly work, turn
regulator to its fully open position.
This im pact wrench is rated at 1/2"
USS bolt size. Rating must be down
graded for spring U bolts, tie bolts,
long cap screws, double depth nuts,
badly rusted conditions and spring
fas ten ers, as they absorb much of
the impact power. When possible,
clamp or wedge the bolt to prevent
springback.
Soak rusted nuts in pen e trat ing oil
and break rust seal before removing
with im
pact wrench. If nut does
not start to move in three to five
sec
onds, use a larger size impact
wrench. Do not use impact wrench
be yond rated ca pac i ty, as this will
dras ti cal ly reduce tool life.
The forward/reverse lever is used
to change the direction of the tool.
When the lever is moved to the right,
the tool is in a forward or right hand
direction. When the lever is moved
to the left, the direction is reverse or
left hand.
NOTE: Actual torque on a fastener is
directly related to joint hardness, tool
speed, condition of socket and the
time the tool is allowed to impact.
Use the simplest possible tool-to-
socket hook up. Every connection
absorbs energy and reduces power
OPERATION
Specifications
Max.
Free Speed .......................7,500 RPM
Max Torque ........................675 ft. lbs.
Breakaway Torque ..........1,100 ft. lbs.
Air Inlet ............................... 1/4" NPT
Recommended Hose Size ...3/8" I.D.
Avg. Air Cons. ..................... 4.7 CFM
Max. Air Pressure .....90 psig (6.2 bar)
Weight .................................... 5.9 lbs.
Length ......................................... 8.1"
Width ........................................... 2.8"
Height .......................................... 8.2"
WARRANTY
Important: DO NOT RETURN DEFECTIVE PRODUCT OUTSIDE OF ORIGINAL ONE (1) YEAR WARRANTY PERIOD TO
PLACE OF PURCHASE.
WARRANTY POLICY:
This Carlyle Air Tool is warranted against defects in material and workmanship for a period of One (1) Year
from the date of original purchase. We will replace, at our option, any part which proves to be defective in material or workman
ship. Repairs or replacements are warranted as described above for the duration of the original warranty period. In the unlikely
event a replacement unit is required during this One (1) year period, return the unit to your local NAPA Auto Parts Store for a
replacement. This warranty does not apply to products which have been subjected to abuse, misuse, modification, neglect, lack of
maintenance, use in a productionrelated service, or repaired by anyone other than an Authorized Carlyle Air Tool Service Center.
For complete listing of Authorized Master Repair Centers, see enclosed Customer Warranty Repair Form, or
visit www.toolwarrantyrepair.com
Air Inlet
Forward/
Reverse
Lever
