14
WI1024B 2WAY-UNIVKF
Installation Instructions
Universal Operation
Enrolling and Removing KeyFobs
Each KeyFob used in the system must be enrolled into the receiver
using the following procedure:
1
Use a pen or pencil to depress and hold the recessed
Enroll Mode Push Button on the top of the receiver.
Release when the Enroll Mode LED begins to flash.
Entered
Enroll Mode - The Enroll Mode LED will
continue to flash.
2
Press the
∗∗
button on KeyFob 1.
The KeyFob will sound a confirmation beep.
3
Press the
∗∗
button on KeyFob 2 (if more than one).
The KeyFob will sound a confirmation beep.
...
Repeat for each KeyFob to be programmed into system.
•
Hold Down Enroll Mode Push Button or KeyFob
ON/OFF
.
Exit Enroll Mode - the Enroll Mode LED will go out.
To remove a lost KeyFob from the system:
Enter and then exit the Keyfob Enroll Mode. (Hold down Enroll Mode
Push Button until Enroll Mode LED flashes, release and then hold down again to exit Enroll Mode). All keyfobs will be
deleted from system.
!
Enroll Mode
LED
Receiver
Enroll Mode
Push Button
STEP 2
- ENROLLING KEYFOBS
