17
Universal Operation
Wiring for Garage Door Control
In Universal operation, the 2WAY-UNIVKF may be used to
control a garage door opener, or any other access control
device which requires a momentary closure for activation.
The typical installation will require that the N/O and COM
terminals of Relay 3 be wired across the wall mounted
push-button switch for the garage door control as shown in
the diagram below.
•
Pressing the
∗∗
button will provide a 2 second short
across these terminals, prompting the garage door
opener to activate.
Garage door opener wall mounted
push-button switch, or normally open
garage door opener input.
Typical wiring for a controlling a
garage door opener from KeyFob.
COM
14
N/O
N/C
15
16
GARAGE DOOR CONTROL
Note: There is no need to re-enroll the KeyFobs after
a battery change.
Use only AAA 1.5 Volt alkaline battery.
3
Replace battery compartment cover
Changing the KeyFob battery
G
1
Open battery compartment on back of Keyfob.
AAA
+
2
Remove old battery and replace with new.
