8
WI1024B 2WAY-UNIVKF
Installation Instructions
STEP 1
- WIRING AND CONFIGURATION
Mounting
The 2 way receiver should be mounted in a location which is centrally located
in the area of anticipated usage. It is not recommended that the receiver be
installed in an attic or mounted within 24 inches of any metallic objects.
Installation in a basement will result in reduced range. It should not be mounted
in the control panel enclosure. The receiver should be positioned with the
antennas pointed up.
Wiring
The 2WAY-UNIVKF is compatible with the keypad bus of the NAPCO Gemini
GEM-P816, GEM-P1632, GEM-P3200 and GEM-P9600 control panels. It is
also compatible with the keypad bus of the Ademco models Vista 10 and 20.
Note: for Bus Operation, DO NOT connect any wires to terminals 5 & 6.
Programming
The Gemini control panel must be programmed for an additional keypad.
For
example if the installation currently has 2 keypads, an additional keypad,
keypad # 3 must be enabled in programming.
This is not required for the
Ademco Vista 10 and 20.
If KeyFob panic is desired, Keypad Panic should be enabled in the control
panel program. For the Ademco Vista 10 and 20, zone 95 must be programmed
for 24 Hr Audible or 24 Hr Silent. For the Vista 20 zone 99 must be
programmed for 24 Hr Audible or 24 Hr Silent.
Configuring the Receiver Address
For the NAPCO Gemini bus operation, the receiver must be addressed to
match the address of the additional keypad enabled in programming above.
For
example, if the receiver is to be addressed as keypad 3, refer to the Receiver
Address Chart and install the appropriate address jumpers (J8 off, J9 ON,
J10 ON). This is not required for the Ademco Vista 10 and 20.
Configuring the Control Panel Type
For a bus compatible installations only, refer to the Panel Type Configuration
RECEIVER
GND
+12V
TX
4
1
2
3
RX
12
9
10
11
RED
BLACK
GREEN
YELLOW
GEMINI PANEL
RECEIVER ADDRESS CHART
KEYPAD
ADDRESS JUMPERS
#
J8
J9
J10
1
off
off
off
1
off
off
ON
2
off
ON
off
3
off
ON
ON
4
ON
off
off
5
ON
off
ON
6
ON
ON
off
7
ON
ON
ON
PANEL TYPE CONFIG. CHART
PANEL TYPE
CONFIG. JUMPERS
J3
J4
J5
NAPCO GEM-P816, P1632, P3200, P9600
off
off
off
Ademco Vista 10, 20
off
off
ON
Ademco 40, 50
off
ON
off
RECEIVER
GND
+12V
TX
4
1
2
3
RX
RED
BLACK
GREEN
YELLOW
ADEMCO PANEL
NAPCO Gemini & Ademco Bus Operation
