NAPCO 2WAY-UNIVKF, Installation Instructions Manual

9

STEP 2

  -   ENROLLING KEYFOBS

Enrolling and Removing KeyFobs

Each KeyFob to be used in the system must be enrolled into the receiver. The following procedure is used to enroll
the unique RF ID number stored in the non volatile memory of each KeyFob into the receiver memory.

1

Arm system from any keypad

2

Disarm system from any keypad

3

Enter Unique Code 

1114

 [ON/OFF] / [STAY]

The Enroll Mode LED will flash rapidly.

The keypad will give error beeps - ignore.

4

Press the 

∗∗

 button on KeyFob 1

The KeyFob will sound a confirmation beep.

....

Repeat for each KeyFob to be enrolled

• 

Press [RESET] on Keypad OR [ON/OFF] on Keyfob

Exit Enroll Mode - the Enroll Mode LED will go out

• 

All instructions which require keystroke entry on the NAPCO or Ademco keypad will be followed by the appropriate button in
[NAPCO] / [Ademco] format. For example [ON/OFF] / [STAY].

• 

The Keyfob Enroll Mode may also be entered / exited by pressing the  the Enroll Mode Push Button on the top of the
receiver. See page 15 for more information.

To Remove a lost KeyFob from the system: 

Enter and then exit the Keyfob Enroll Mode. Enter 1114  [ON/OFF] /

[STAY] and then press [RESET]. All keyfobs will be deleted from the system.

NAPCO Gemini & Ademco Bus Mode