L
NAPCO Security Systems
Freedom F-64 Programming Instructions
Page 39
WI1502A 9/06
*
Initial Configuration Only
(new or memory cleared panel);
suppressed thereafter. Normal entry mode for previously
programmed panel starts at "
# AREA 1 KEYPADS
".
EASY MENU DRIVEN
PROGRAM MODE
#of Zns in Area1*
EZ Zone Doubling Enabled?*
Fire Zones*
2-Wire Fire Zns*
Report All ZonesTo Central?*
Exit/Entry Zones*
Interior Zones*
24 Hour Zones*
Chime Zones*
Chime 2 Zones*
Exit/Entry 2 Zones*
50mS Loop Zones*
Aux Output Zones*
Sensor Watch Zns*
KP Sndr Alrm Zns*
Auto Byp REnt Zn
Enable No EOLR Zones*
Enable Telco Line Test?*
Enable Burg Out Chirp?*
Enable CP01 Programming?*
# Area 1 Keypads
Prog a Freedom KP?
Enter Freedom KeyPad #
Enter KeyPad PIR Zone #
Enter Door1 Zone #
Enter Door2 Zone #
Chime 1 Zone #
Chime 2 Zone #
Aux2 Zone #
Add Another Freedom Touch-
pad?
Central Phone #
Central Station Account #
See WI for Info Rcvr Format
Enter user code
ZN# XMIT#+CS P
KF A XMIT#+CS OP
01 (ZONE DESCRIPTIONS)
Enter Date
Enter Time
Dealer Code
Test Timer
TO EXIT PRESS
C
AT ANY TIME
DIRECT
ADDRESS
PROGRAM
MODE
(see WI1502 for
more information
DEALER PROGRAM MODE OVERVIEW
TO EXIT PRESS
.
C
AT ANY TIME
For the F-64PROG Programmer
Scroll Down
Scroll Up
Exit
Yes
No
Dealer Program Mode
comprises two operational states:
•
EASY MENU DRIVEN PROGRAM MODE
-
Used with new "out of the box" panels
(or "Cold Started" panels, see address 2286), this mode allows the dealer to customize
the factory panel program to best suit the installation. The
Easy Menu-Driven Pro-
gram Mode
is a menu-driven utility that prompts the installer to configure the system.
Press
C
at any time to exit, thus entering
Direct Address Program Mode
, detailed
below.
•
DIRECT ADDRESS PROGRAM MODE
-
Additional programming changes, if nec-
essary, can be made in the
Direct Address Program Mode
. In this mode, the pro-
gramming address is accessed directly and re-configured by the installer. For more in-
formation, see "DEALER PROGRAM - PRELIMINARY INFORMATION" on page 5.
TYPICAL USER
: Dealers / Installers only.
TYPICAL INTERFACE
: An
F-64PROG
programmer.
HOW TO ENTER
: Press the factory-installed default
Dealer Code
:
456789R
. Press
AWAY ("NO")
until
"
ACTIVATE PROGRAM Y/N
" appears on LCD screen. Press
STAY ("YES")
to enter
the
Easy Menu-Driven Program Mode
. See Programming Instructions (WI1502)
for additional information regarding the
Easy Menu Driven Program Mode
.
To exit
, press
C
to enter
Direct Address Program Mode
and press
C
once again to exit
Dealer Program Mode
.
