19
AD V AN C E D F E AT U R E S
'
Area Arming (Area Arming programmed? YES NO.)
In a system that has been partitioned into multiple areas, one or more areas
may be armed while others remain disarmed.
Manager's Mode. The Manager's Mode, if enabled, provides quick access to
other areas without the system status display. (This is
not a high-security feature.)
To arm any area:
1. Press the numerical key representing the area number.
2. Press the
button, then press
. In effect, you will now be in that area.
3. Enter your code, then press
to arm (code must be valid in that area).
To arm all areas simultaneously (including the area you are in):
1. Press the
button, then press the
button.
2. Enter your code, then press
to arm.
If any zone is not secured, the keypad will display “
”, where “
” identifies the area number. All problem zones in the respective
area must be secured or bypassed before the area can be armed. Note: If a sys-
tem trouble is indicated, the system cannot be armed using this method.
To disarm all areas, press
,
, enter your code and press
.
GEM-RP1CAE2.pub
page 19
Tuesday, September 29, 1998 09:28
