NAPCO iBridge Suite, Quick Start Manual

13 

STEP 8: ACTIVATE YOUR IBRIDGE (IBR-ZREMOTE) FOR REMOTE SERVICES 

Once the IBR-ZREMOTE has been completely wired to the control panel, configured and powered up, a consumer 
iBridge subscriber account is ready to be created for remote services (remote access through the web and remotely 
through smartphones), if desired.  These activation steps include adding subscribers, cameras and an IBR-ZREMOTE 
to a customer account. 
 
To activate, go to 

www.NapcoComNet.com

 and log into your NapcoComNet account.  If you are not 

yet registered as a NapcoComNet dealer, please click the 

Registration

 button.  Dealer accounts are 

approved Monday-Friday 8:30am-4:30pm (please allow up to 1 business day for approval). 
 
To activate your new device, click the 

Add Device

 tab at the top of the screen, click 

Service Plans

 and 

then enter the device's Unit ID / MAC Address for the product type that you are activating. 
 
Select:   



SLE-GSM Service Plans:

  Type the Radio ID# for all Napco SLE-Series Radio models  



iSeeVideo Service Plans:

  Type the MAC address for all iSeeVideo cameras, IVRs and Vid-

eo Gateways (do not activate the ISEE-WAP) 



iBridge/iRemote Service Plans:

  Type the MAC address for iBridge and iRemote modules 

 
Simply enter your device’s 

Unit ID / MAC address

 (without dashes or spaces) and click 

Go

 to view the applicable ser-

MAC 

ADDRESS 

Test the keypad. 

 To ensure the IBR-ITAB is connected 

with the correct ISEE-WAP, press the 

Back/Power Button

repeatedly until the Home Screen appears, then press the 

Security 

button.  A screen with your arming choices ap-

pears: 

Arm the system by first pressing 

AWAY

, then press the User 

Code in the keypad that appears.  Ensure the keypad text on 
the IBR-ITAB matches the keypad text that appears on the 
standard wired keypad.   

In the Home Screen, when connected, a con-
nection strength indicator appears at the top 
right (1-4 bars, as shown).  If you wish to verify 
the connection, press this icon and text ap-
pears at the bottom of the IBR-ITAB screen 
confirming the validity of the connection.  For 
example, the text may read: 

"

Connected with ssid:  WAP345, Level: Excellent, IP: 

192.168.50.102, Port: 8003, Gateway: 192.168.50.2

" 

Signal Strength 

Indicator 

USING NL-MOD CONFIG Software 3.0.2.1 or greater  

Verify the correct IP Address to our DNS server as follows:  

Note:

  You will only need to perform this next step if 

you are unable to access the IBR-ZREMOTE remotely and/or if the red LED located on the top center of the 
bottom PC board inside the IBR-ZREMOTE is NOT blinking every 15 seconds (this blinking LED normally indi-
cates a successful connection to our DNS server). 

Open the NL-MODCONFIG software.  Click the "

PC Preset/RCM

" tab, click the 

Secondary 

tab (located on the 

right) and click "

Populate Napco Defaults

" button.   

 
In the 

Populate Defaults for Device 

popup 

(shown at left), populate the defaults for the 

IBR-ZREMOTE

 (click the radio button and 

click 

OK

).  When finished, download these 

changes to the IBR-ZREMOTE.