32
U S E R S E T T I N G S
Setup Wizard
Tap to re-start the Setup Wizard to configure how the
app will be used, its Wi-Fi connection settings to the
customer's Wi-Fi network and iBridge radio, and op-
tionally the NAPCO StarLink account(s). See the
NAP-
CO iBridge IBR-TOUCH & IBR-TOUCH-WL Quick
Start Guide
(WI2297) for step-by-step instructions to
help guide you through the Wizard.
Run Diagnostics
Tap to run a system diagnostics test for components
selected the last time the
Setup Wizard
was run
(typically when the touchscreen was first powered).
Functional components are marked with a check; items
not configured or not enabled are marked with an "x".
Selections are blank when the Wizard is run for the first
time. If you wish to continue through the
Setup Wizard
(described below), tap
Configure
; otherwise tap
Contin-
ue to App
to return to the Home Screen (or
Test
Again
to repeat the test). See the
NAPCO iBridge
IBR-TOUCH & IBR-TOUCH-WL Quick Start Guide
(WI2297) for step-by-step instructions to help guide you
through the Wizard.
Test Wi-Fi connection
Tap to analyze the strength of the wireless connection
between the device running the app and the customer's
router (and/or ISEE-WAP). When installing, be sure
the large "Wi-Fi Icon" is colored green (OK) to ensure a
strong wireless signal. In addition, the signal strength
in dBm units (signal level relative to 1 milliwatt) is pro-
vided for those more familiar with readings expressed
using standard radio communication terminology. The
dBm units are expressed in negative numbers; there-
fore the higher the negative number, the weaker the
signal. For example, a reading of -20 is stronger than -
30.
Clean Tablet Screen
Allows you to safely clean the touchscreen display sur-
face without making changes to the system. Tap to set
a length of time during which all inputs to the system
through the touchscreen are disabled. Enter a time in
seconds, tap
Yes
, and the screen will turn black with
dark gray numbers counting up to the number of sec-
onds entered, then will count down to zero and return
to normal operation. For example, entering "20" will
disable the keypad for a total of 40 seconds.
Change LED Level
Provides a sliding bar to control the brightness of the
red and green LEDs located on the face of the tablet.
