45
E18-NNN -- Keyfob Transmitter Low
Battery
A keyfob transmitter has indicated its
power cell(s) are weak and should be
replaced. The 4-button ISEC-
KEYFOB uses a 3V Lithium coin cell
battery (replace with type CR2032 or
Duracell DL2032 only). The 1-button
ISEC-PANIC uses two Energizer 386
1.5V silver oxide cells (the unit will
also flash its LED to warn of a low-
battery).
Warning:
Replace batteries
only with the same type as specified
above. Use of another battery may
present a risk of fire or explosion. Do
not recharge or disassemble battery,
or dispose of in fire.
E40-NNN -- RF Self-Test Failure
A wireless motion sensor on the zone
indicated has failed its automatic self-
test routine. Call installing company
for service.
E41-NNN -- Fire Trouble
A problem has been detected on the
fire zone indicated. Call installing
company for service.
E42-NNN -- CO Zone trouble
A problem has been detected on the
carbon monoxide zone indicated.
Call installing company for service.
E51 -- Bell/Siren Trouble
There is a problem with the bell or
siren. Call installing company for
service.
E59-03 -- Ethernet failed to communi-
cate
Call installing company for service.
E59-04 -- Ethernet poll/check-in fail-
ure
Call installing company for service.
E59-07 -- Wi-Fi failed to communicate
Call installing company for service.
E59-08 -- Wi-Fi poll/check-in fail
Call installing company for service.
E60-03 -- Radio failed to communi-
cate
Call installing company for service.
E60-05 -- Radio Poll or Check in fail-
ure (RF only)
Call installing company for service.
S Y S T E M T R O U B L E E R R O R C O D E S ( c o n t ' d )
