NAPCO Security Systems
LIBRA LIB-P432EX Series Programming Instructions
Page 41
(Direct Entry)
ZONE DESCRIPTIONS (GEM-DXRP1 / GEM-DXK1 KEYPADS)
Enter an identifying description for each zone. Characters are selected by
pressing keypad buttons multiple times, "Cell Phone" style. Buttons
1
through
9
plus
0
and
G
are used, as per the following table:
Press
w
to move cursor right.
Press
x
to move cursor left.
Notes:
1. After releasing the number button for 2 seconds, the character will be accepted and the cursor advanced to the
right.
2. After releasing the number button, if a new number button is pressed before the 2 second window expires, the cur-
rent character will be accepted and the cursor automatically advanced to the right. The first of the 4 characters of
this new number button will be displayed.
3. To erase an existing entry, use
w
or
x
to move the cursor below the character to be changed. Enter a
new character to overwrite the old, or press zero to delete the character.
4. To generate lowercase characters, the
G
button must be pressed and held down while pressing the number
button. If the
G
button is released during the 2 second window, the current character will change to uppercase.
Press
u
to save.
To advance to the next zone (or to any other zone), move the cursor to the displayed zone number (i.e., "01") using
w
and
x
. Change the zone number using keys
0
through
9
. Enter two digits for the zone number
(after entering the first digit, the cursor will automatically advance to the second digit). When the second zone number
digit is entered, the cursor will automatically advance to the right, allowing the description locations to be entered.
Always press
u
to save each zone description.
Enter Date
(Press the
w
button to set cursor.)
Enter the current date in the format MM/DD/YY, where MM = the month (01–12);
DD=the day (01–31); and YY=the year. Press
u
to save. Press NEXT ("
r
" or
p
) to proceed.
Enter Time
(Press the
w
button to set cursor.)
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
MM=minutes (00–59). Select AM or PM by pressing any number button, then press
u
once again to save.
NOTE:
To enter the date and time, GEM-DXRP1/GEM-DXK1 keypad (version 9A or greater) must be used and "Enable
Keypad Time/Date Display" (Address 1420) must be enabled.
01-
(Direct Entry)
(Direct Entry)
Enter Date
( / / )
Enter Time
( : )
PRESS:
CHARACTERS DISPLAYED
IN SEQUENCE
HOLD
G
AND PRESS:
CHARACTERS DISPLAYED
IN SEQUENCE
[
1
]
ABC1
[
1
]
abc1
[
2
]
DEF2
[
2
]
def2
[
3
]
GHI3
[
3
]
ghi3
[
4
]
JKL4
[
4
]
jkl4
[
5
]
MNO5
[
5
]
mno5
[
6
]
PQR6
[
6
]
pqr6
[
7
]
STU7
[
7
]
stu7
[
8
]
VWX8
[
8
]
vwx8
[
9
]
YZ90
[
9
]
yz9
0
[
0
]
(SPACE) • - . ( ) , / : ? #
[
0
]
(Reserved)
