ArchiTech Mortise Lock & Surface-Mounted Networx Control Unit Mounting and Installation Instructions
10
PROXIMITY READER INSTALLATION
Find the reader type provided, either rectangular or oval. If you have a
Rectangular Proximity Reader
, go to step 15. If
you have an
Oval Proximity Reader
, go to step 14 below.
14. OVAL PROXIMITY READER INSTALLATION
If you have a "
Rectangular
"
Proximity Reader
, go to step 15.
Note that the
Oval Mounting Plate
is symmetrical, and therefore has no "top" or "bottom".
14A. INSTALL THE "OVAL RUBBER GASKET" AND THE
"OVAL MOUNTING PLATE"
See Fig. 14A. Place the
Oval Rubber Gasket
(with its
attached
Oval Mounting Plate
) against the door sur-
face, over the wire passage hole that was drilled into
the door in step 9C.
Secure
(
snug-tight only, do not over-tighten
) using the
two Phillips Pan Head screws appropriate for the door
type as follows:
For Metal Doors:
#6-32
x 1/2" long Type F thread
cutting Phillips head (part
#SC212);
For Wood Doors:
#6 x
1/2" long Type A Phillips
head (part #SC265)
Again,
do
NOT
over-tighten these screws; over-
tightening will cause undesired deformation of the
Rub-
ber Gasket
.
FIG. C: OVAL PROXIMITY READER
(GO TO STEP 14 BELOW)
FIG. D: RECTANGULAR PROXIMITY READER
(GO TO STEP 15)
Option 1
Option 2
DO NOT
USE
POWER
DRILLS
OR
POWER
SCREWDRIVERS
WHEN
INSTALLING
THE
P
ROXIMITY
R
EADER
!
FIG. 14A: "OVAL MOUNTING PLATE" (WITH LEFT
AND RIGHT "TABS") AND THE ATTACHED
"OVAL RUBBER GASKET"
Oval Mounting Plate
Oval Rubber
Gasket
Left Tab
Right Tab
OVAL
Thru-Hole
