A. Assemble the awning poles by
unfolding each section.
B. Place the end of the pole with
the pin through the grommet hole
at the corner of the awning.
C. Place the ring end of the guy line
over the pole pin located at the top
of the awning. Place the awning
cap over the pin.
A. Stake the bottom loop of the guy line (bottom
portion of plastic slider) to the ground with a peg.
Repeat for all awning guy lines.
B. Adjust the length of the guy lines by pushing the
plastic slider upwards until the line is tight.
19
20
Stake down the tent and screen room
through the corner and side webbing
loops.
14
To install the gear loft, place each
corner hook of the gear loft into
the loop located on the ceiling of
the tent.
21
setting up the awning
Stake the rainfly guy lines to the ground.
18
Drape the rainfly over the tent. The side that says “Vehicle Side” goes towards the vehicle.
Attach the rainfly to the clips found at the bottom corners of the tent. Tighten the straps
and secure the Velcro tabs around the poles.
At the top corner of the rainfly, locate the elastic strap with the plastic hook. Secure it to
the steel loop on the tent pole. Repeat on the opposite corner.
15
16
17
20B
20A
19c
attaching the rainfly