22
W415-0762 / A / 07.19.10
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to
prevent drywall dust from coming into contact with the blower or its compartment. Any damage resulting from
this condition is not covered by the warranty
policy.
Use of the blower increases the output of heat.
NOTE: If the optional blower (EP62-1) is
installed, the blower guard (W320-0011)
must be installed. This guard is available
from your Napoleon dealer.
Attach the mounting bracket to the blower
assembly. Then attach the mounting bracket
to the back of your appliance, push on
the variable speed knob and plug into any
grounded electrical outlet. See “BLOWER
INSTALLATION” leafl et for detailed
instructions.
MOUNTING
BRACKET
BLOWER GUARD
VARIABLE
SPEED
SWITCH
BLOWER
ASSEMBLY
6.1 OPTIONAL BLOWER INSTALLATION
6.2 OPTIONAL ASH DRAWER
Provisions have been made on the appliance to
install an optional ash drawer kit.
The EPAD-KT kit allows for convenient removal
of excess ash. This kit can be purchased through
your authorized dealer / distributor.
6.0 OPTIONAL KIT INSTALLATIONS
IMPROPER DISPOSAL OF ASHES RESULT IN FIRES. DO NOT DISCARD ASHES IN CARDBOARD
BOXES, DUMP IN BACK YARDS, OR STORE IN GARAGES.
IF USING A VACUUM TO CLEAN UP ASHES, BE SURE THE ASHES ARE ENTIRELY COOLED. USING
A VACUUM TO CLEAN UP WARM ASHES COULD CAUSE A FIRE INSIDE THE VACUUM.
NEVER OPERATE YOUR APPLIANCE WITH THE GRATE COVER REMOVED.
FAILURE TO ACHIEVE A GOOD SEAL BETWEEN THE ASH OPENING, ASH PLUG OR ASH WELL DOOR
WILL RESULT IN AN OVER FIRE CONDITION THAT COULD CAUSE DAMAGE TO THE APPLIANCE.
!
WARNING
!
WARNING
RISK OF FIRE AND ELECTRICAL SHOCK.
TURN OFF THE ELECTRICAL POWER BEFORE SERVICING THIS APPLIANCE.
USE ONLY WOLF STEEL APPROVED OPTIONAL ACCESSORIES AND REPLACEMENT PARTS WITH
THIS APPLIANCE. USING NON-LISTED ACCESSORIES (BLOWERS, DOORS, LOUVRES, TRIMS, ETC.)
COULD RESULT IN A SAFETY HAZARD AND WILL VOID THE WARRANTY AND CERTIFICATION.
ENSURE THAT THE BLOWER’S POWER CORD IS NOT IN CONTACT WITH ANY SURFACE OF THE
APPLIANCE TO PREVENT ELECTRICAL SHOCK OR FIRE DAMAGE. DO NOT RUN THE POWER
CORD BENEATH THE APPLIANCE.