W415-0616 / E / 10.08.08
30
A.
Open the side doors on either side of
the heater.
B.
On the right side of the heater are two
latches. Release the latches by pulling
the rear handle forward and
disengaging the hook from the door
frame. Swing open the viewing door.
The front of the heater becomes very hot during operation. Let the heater cool completely before
conducting service.
!
WARNING
Latch
Side
Door
9.0 GENERAL mAINTENANCE
9.1 dAILY (WhENEvER USING ThE hEATER)
9.1.1 OPEN mAIN vIEWING dOOR
9.1.2 dISPOSAL OF AShES
9.1.3 INSPECT ThE BURN POT
9.1.4 CARE OF GLASS ANd PLATEd PARTS
Ashes should be placed in a metal container with a tight fitting lid. The container should be placed on a non-
combustible floor, well away from combustible materials, pending final disposal. If ashes are disposed of by
burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are
thoroughly cooled.
When burning, the flames should be bright orange with embers jumping from the burn
pot.
If not see “MAKE SURE PELLETS ARE NOT PILING UP” or “CLEANING THE
BURNPOT” sections.
TP - mAIN vIEWING dOOR_PEllET
TP - dISPOSAl OF AShES_PEllET
TP - INSPECT bURN POT_PEllET
TP - CARE OF GlASS
fIGure 9.1.1a
fIGure 9.1.1b
fIGure 9.1.3
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE ABRASIVE
CLEANERS TO CLEAN GLASS OR PLATED PARTS.
Buff lightly with a clean dry soft cloth. Clean the glass after the first 10
hours of operation with a recommended fireplace glass cleaner.
Thereafter clean as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
Refer to “REPLACEMENT PARTS” to find out what this product is
equipped with and the thickness of the glass.
Use only replacement glass available from your Authorized dealer.
DO NOT SUBSTITUTE MATERIALS.
If the appliance is equipped with plated parts, you must clean fingerprints or other marks from the plated surfaces before
operating the appliance for the first time. Use a glass cleaner or vinegar and towel to clean. If not cleaned properly before
operating for the first time, the marks can cause permanent blemishes on the plating. After the plating is cured, the finger-
prints and oils will not affect the finish and little maintenance is required, just wipe clean as needed.
Summary of Contents for Auburn NPS40
