2
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada • phone 866-820-8686 • w w w . n a p o l e o n h e a t i n g a n d c o o l i n g . c o m
D
6
4A
4B
4C
Install D channel gasket
to the edge of the flanges
.
Architectural grille
Wall
Sleeve
GASKET
Upper
Stamped Grille
Condo Pack
Cabinet
Condo Pack
Cabinet
Wall Sleeve
Wall
Sleeve
Arch.
Grille
STEP 4:
Apply self-adhesive D-Channel gasket strips (W290-0256,
included with Condo Pack cabinet to inside surface
of sleeve front flanges. Make sure that gasket is lined up
with the EDGES of the wall sleeve flanges (detail 4A).
STEP 5:
Remove factory installed upper stamped
grille from the Condo Pack cabinet as shown.
Discard upper stamped grille.
STEP 6:
Install Condo Pack cabinet into the wall sleeve. Make sure
the gaskets attached to the sleeve are not damaged.
Make sure that the cabinet seats tight against the
gasketing previously installed on the wall sleeve. Refer to
Wall Sleeve instructions for squaring braces removal.
IMPORTANT
!
!
THE FACTORY INSTALLED
UPPER STAMPED GRILLE
MUST BE REMOVED
FROM THE CONDO PACK CABINET, PRIOR TO UNIT
INSTALLATION INTO THE WALL SLEEVE.
VIEW OF UPPER CORNER FROM
INSIDE OF WALL SLEEVE
- Apply self-adhesive
D-Channel gasket strips
to inside surface of sleeve
front FLANGES and onto
the BASE PANEL,
as shown in detail 4B.
ARCHITECTURAL GRILLE IS DESIGNED TO BE INSTALLED ONTO A WALL SLEEVE
PRIOR
TO CONDO PACK
INSTALLATION. IT IS RECOMMENDED THAT THIS STEP IS PERFORMED
AFTER
CONSTRUCTION PHASE HAS BEEN COMPLETED.
FOR COMPLETE INSTALLATION PROCEDURE REFER TO CONDO PACK INSTALLATION MANUAL
IMPORTANT
!
WASHER, 0.174ID x 0.375OD x 0.125" THK NYL 6/6
SCREW, #8 x 1” HEX DRIVE TEKS SS
Self-adhesive D-channel gasket
installed to the flanges’ edge.
OUTSIDE
A
rchit
ec
tur
al Gr
ille
INSIDE
BASE
SUPPORTING
BRACKET
SIDE PANEL
BASE PANEL
GASKE
T
GASKE
T
Flanges
Flanges
GASKET
Make sure the gasket
strips are applied
along the EDGES
of the Wall
Sleeve flanges.
W290-0256
GASKE
T
GASKET
D
GASKE
T
SIDE
PANEL
BASE
PANEL
4C
4B
5
!
