W415-1139 / C / 05.14.13
14
EN
6.0 MAINTENANCE
!
WARNING
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE LED BULBS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST 10
MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE BULBS TO AVOID
ACCIDENTAL BURNS.
6.1 REMOTE BATTERY INSTALLATION
1. To replace the existing battery remove the
battery holder.
2. To remove the battery holder turn remote onto
front side and press the left side leaver towards
the center while pulling the battery holder out
using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
4. Battery holder is secure into the remote control
when a "CLICKING" noise is heard.
REMOTE
(REAR SIDE)
BATTERY HOLDER
BATTERY (CR 2025)
